Materials:
-
Category 5 UTP Cable
-
2 RJ-45 Connector
-
Cutter
-
Crimper
-
Stripper
Procedure:
-
Strip about an inch of the plastic jacket. Be very careful not to cut the wires inside the jacket as this will alter its condition or make it useless.
-
Separate the wires inside the jacket. Untwist those wires and make sure that the untwisted wires are only about ½ inch otherwise it will be “out of specs”.
-
Arrange the wires in the same way listed below,
-
Crossover Connection
-
Straight-through Connection
After arranging the wires, carefully cut those wires evenly about ½ inch from the jacket.
-
Insert those wires in the RJ-45 connector. Make sure that the end of each wire touches the tip of the connector.
-
Insert the connector to the crimper and give it a good grip. You will here some clicking sound. Keep pressing it for a couple of second until the clicking sound stop.
-
Test the cable and hope that it works. That’s all.
I just hope you guys will have the same experience as I did in making those cables. I only did it ones and it worked! THANK GOD! The hardest part there was the untwisting the wires properly and arranging the colors. That’s all. Good Luck to you all!
